:  May 25, 2004



.
  : Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

Raise and support the vehicle.

. Remove both rear lamp assemblies.

. Remove both rear quarter panel mouldings.

. Remove 4 scews, 2 clips and 2 bolts from the rear bumper cover.



. With assistance, remove 4 clips from the inner edge of the bumper cover.
  Tilt the tailgate for access.
  Open the tailgate hinge cover.




. Remove the rear bumper cover.
  Release from the 12 clips.
  If installed, disconnect the parking aid sensor wiring harness electrical connector.




. :
  Do not disassemble further if the component is removed for access only.

Remove the towing eye cover.
  Remove the 2 screws.




. Remove the rear bumper trim panel.
  Release the 11 clips.




. Remove the bumper insert.
  Remove the 3 screws.

. Remove the parking aid sensor wiring harness.
  Disconnect the 4 electrical connectors.




. Remove the parking aid sensor.
  Release the 2 clips.
  Repeat the above procedure for the remaining 3 sensors.




. Remove the parking aid sensor trim panel.
  Release the 3 clips.
  Repeat the above procedure for the remaining 3 sensor trim panels.




. Install the parking aid sensor trim panels.

. Install the parking aid sensors.

. Install the parking aid sensor wiring harness.
  Connect the electrical connectors.

. Install the bumper insert.
  If installed, secure the parking aid sensor wiring harness.
  Tighten the screws.

. Install the rear bumper trim panel.

. Install the towing eye cover.
  Tighten the screws.

. Install the rear bumper cover.
  If installed, connect the parking aid sensor wiring harness electrical connector.
  Secure with the clips.
  Tighten the screws.
  Tighten the bolts to 10 Nm (7 lb.ft).

. Install both rear quarter panel mouldings.

. Install both of the rear lamp assemblies.